If your generator boiler has an anti-calc rod, take this out and rinse it under the tap before placing it back in the boiler. If you live in a hard water area, do this more often. Most of all, do not use any descaling products to clean the boiler as they could damage it. Descaling operation is not needed for the steam generator, nevertheless, you could rinse the boiler every 10 uses refer to user manual. Never use any descaling agent or vinegar when rinsing the boiler: they could damage it.
The next time you use your generator, press the "restart" button to turn off the orange "Anti-calc" light depending on model. For easier, non-corrosive cleaning of your iron's soleplate, use a damp sponge on the soleplate while it is still warm.
If cleaning dirt off is an issue, use the stick which is made specifically for cleaning the Durillium soleplates. Warning: The use of iron cleaner will cause damage to your soleplate's autoclean coating. When starting or using the steam generator you may hear a pumping or vibrating noise along with a clicking sound. This is completely normal and is just the pump injecting water into the boiler or the steam valve opening.
After rinsing the boiler, you need to press and hold the restart button for about 3 seconds to stop the light flashing. The anti-scale valve plug may be tightened incorrectly or the seal on the inside of the cap has perished. However, if you notice that the steam cord is damaged, have it repaired by an authorised service partner.
Place the iron's temperature control to the type of fabric to be ironed and set the steam output If the setting temperature control is on Synthetics, the setting steam control must be on MIN. It is normal.
Your iron generates a lot of steam; this steam is condensing on the board. Some waterdrops could appeared underneath the ironing board and fall on the flooring. If the boiler does not operate or the red light on the control panel comes on even though there is still water left in the tank, we suggest you check the water tank is not empty.
You can also check the removable water tank depending on model is pressed down firmly in place and press the restart button located on the control panel. Also the steam output control dial may be set at minimum depending on Model ; therefore turn the dial up to increase the steam.
If your red water light is flashing there is no water in the water tank or the tank is not fully or firmly pushed down. Depending on the model of generator, when ironing on a low temperature, decrease the steam output by adjusting the steam output dial on the control panel. Wait for the iron temperature control light to go out before ironing. In which case hold the iron away from the ironing board and press the steam control button until it produces steam.
In this case stop using the turbo steam function and allow the iron temperature control light to come on and go off again before using this function again. Do not fill it right to the top.
The generator's safety mechanism has activated. You need to get the generator checked by an authorised service agent. You should never put these products in the water tank. If this is the case, contact an approved service centre. Ensure that you have rinsed your clothes thoroughly in order to to remove soap deposits or chemicals from new garments which could stick to the iron. Only spray starch on the reverse of the fabric to be ironed.
Some laundry starches and synthetic fibres may stick to the surface of the iron. Please clean the Iron's surface. The internal parts may make metallic noises with the change in temperature. There is nothing wrong with it. Yes, this is normal. This is due to the flow of cold water into the boiler that contains hot water. After following the instructions in the user manual for starting the appliance, make sure that your electrical socket is working by plugging another appliance.
If it still does not work, do not try to dismantle or repair the appliance yourself, instead, take it to an approved repair centre. These functions means that your steam generator is fitted with an electronic regulation which offers you the perfect temperature and steam combination allowing you to iron all your ironable fabrics without risk and without having to sort them.
The pressure is at a relatively low level. A steam generator is the most powerful iron that generates vast amounts of powerful steam in a separate boiler unit and pumps that steam constantly and consistently through the iron's soleplate straight into the clothes.
The benefit is that this halves your ironing time and produces fantastic ironing finishes. A steam station is similar to an ordinary iron but has a larger water tank. The water is pumped up to the iron and the steam is generated in the iron not a separate boiler unit. The steam output is constant but not as powerful as a steam generator.
What type of ironing board should I use? The soleplate of my iron is giving off a yellowish colour that is staining my clothes. What is the right temperature for my clothes? How do I prevent water drips on my fabrics? What is the vertical steam function used for? How do I use it?
Can I use my steam iron for Dry Ironing? What should I do if my iron has not been used for a long time? Can I put my iron away right after ironing?
Can I fill the iron with water when it is plugged in? No, you must always unplug the iron before filling it. How can I avoid scratching the soleplate of my iron? How can I avoid shiny marks on fabric? Which water should I use? Maintenance and cleaning. How do I clean the anti-calc valve on my iron? How do I prevent the steam holes of my iron from clogging up? What should I do to maintain my iron correctly? What are the safety rules for iron use? How do I descale my steam iron? I want to remove the water from the tank but there is still a little left.
How do I clean the soleplate? Technical support. My iron is not heating up. Why is my iron leaking from the soleplate when I fill it? Always set your iron to the 'No Steam' function before you start to fill. The auto stop function has been activated. Why isn't my iron steaming when set on the one dot setting depending on model? Why does steam not come out from all of the steam holes?
Why isn't the spray function on my iron working? The indicator light keeps going on and off. Why did my iron smoke on first use? Some waterdrops drip out onto the floor during ironing.
Water flows from the soleplate when the iron is stored or when it is cooling off. My iron is producing no or little steam. What should I do?
Why does my iron release steam once the tank is filled? The iron doesn't glide very easily. White powder or grit is coming out of the steam outlet. A short time after use, I can hear a metallic sound.
What should I do if my appliance is not working? What should I do if the power cable or the cord guard of my appliance is damaged? Do not use your appliance. To avoid any danger, have it replaced by an approved repair centre. Various topics. How do I prevent brown spots from the iron appearing on the clothing? The soleplate is sticking to my garments. What is the anti-calc collector depending on model? What is the function of the Autoclean Catalys soleplate according to model?
What is the advantage of high wattage? The higher the wattage, the faster the iron will reach the desired temperature. Where can I dispose of my appliance at the end of its life span? Where can I buy accessories, spares or consumer goods for my appliance?
What are the guarantee conditions of my appliance? Login Loading Find a qualified repairer for your Tefal appliance or product. Smart Pressure Cooker Accessories. About Tefal. Password lost. You have lost your password. Please enter your email address and we will send you a password Confirm Cancel. Sleep user. Please give us your mail to initialize your password Confirm Cancel.
Our Products. La vente daccessoires nest pas Disponible en ligne pour la. Electrical Cooking. Floor care.
0コメント