A loose axle may lead to an unstable driving behavior of your motorcycle. Do not, in any event, use DOT 5 brake fluid. It is based on silicone oil and is dyed purple. To check the brake fluid level, press the brake pistons back into the basic position. Page Changing Basic Position Of The Brake Pedal mm Checking the rear brake fluid level The reservoir for the rear disk brake is on the right side of the motorcycle on the rear brake cylinder.
The brake fluid level may not drop below the upper edge A of the inspection glass when the bike is in a horizontal position. Note: Glass fiber yarn packages are offered by your licensed KTM dealer. The exhaust system becomes very hot while the motorcycle is running. To avoid burns do not start work on the exhaust system until it has properly cooled down.
Refill oil, until oil is discharged from the bore [7] of the master cylinder in a bubble-free state. Make sure that the oil does not overflow. The bleeder syringe can be purchased from your KTM dealer.
Having completed the bleeding procedure, you have to verify that the oil level in the master cylinder is correct. If necessary, fill up with The cooling liquid is cooled by the air stream. Therefore, the cooling effect is reduced when the traveling speed is reduced. Mixing ratio 2-stroke motor oil : super fuel - Page Draining The Float Chamber Of The Carburetor To check the gear oil, warm up the engine to operating temperature with a low load and place the motorcycle on an even surface.
Remove the oil drain plug [2] and allow the gear oil to drain into a vessel. Clean the sealing area, mount the oil drain plug and gasket and tighten to 15 Nm. Page Trouble Shooting We would like to point out that many operations cannot be performed by oneself. In case of uncertainty, please contact a KTM-dealer. Page Cleaning — Before cleaning with water, plug the exhaust pipe to prevent water ingress.
Then take a short drive until the engine has reached its operating temperature, and also operate the brakes. Page Head Word Index Fuel tap This manual is also suitable for: Xc Xc sx sx 85 sx 85 sx 85 xc Show all sx xc An oil filter must be replaced every kilometres approx. How often should I change the oil of my KTM engine? The oil must be changed every kilometres approx. Soak the rusty part in vinegar until completely soaked through.
Let the vinegar work on the rust for 24 hours. Remove the rust with a wire brush or aluminium foil. This manual is available in English. You also have the option to opt-out of these cookies. But opting out of some of these cookies may affect your browsing experience. Necessary Necessary. Necessary cookies are absolutely essential for the website to function properly. This category only includes cookies that ensures basic functionalities and security features of the website.
These cookies do not store any personal information. Non-necessary Non-necessary.
0コメント