When connected to a network with Internet access, the console will check for a software update each time it is used. If an update is available, the update will automatically download to the console. Once the update is fully downloaded, an onscreen message will appear stating "An update is ready to be installed.
Install now? The Lifestyle and systems cannot be updated through the SoundTouch app. The onscreen instruction will inform you if any automatic updates are ready for installation. To update the bass module, it must be connected to the console wirelessly. If the bass module was connected to the console using a 3. If the Control console has an update for the remote paired to it, the console will update the remote within 10 minutes.
When the update occurs, the remote will not be usable for about 1 minute. Manuals and Downloads. Product guides and manuals. Owner's guide support:. Quick start guide:. Quick setup guide:. Download and install Bose SoundTouch App. The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated dangerous voltage within the system enclosure that may be of sufficient magnitude to constitute a risk of electric shock.
This guide will help you set up and operate your system properly. In bridged mono operation, it is rated at watts. Page 5: Using The Amplifier 3. If a Model amplifier is used with other amplifiers, be sure the heat output from the amplifier does not interfere with the adequate ventilation of the others.
Page 7: Operation 4. Page 8: Level Indicators 4. Page 9 4. Page 11 With EQ cards installed in the Model amplifier, the EQ OUT output of the amplifier can be connected to the line level inputs of additional devices driving the same type of Bose loudspeakers e. Page 15 This will avoid large transient thumps being passed to the loudspeakers attached to the system. Page 16 Let the rack rail be your chassis ground path. Page Installation 5. Turn the power switch to the OFF position. Figure 13 Turning the power switch off Page 20 5.
Install EQ card into the desired channel. Note: If you are using the amplifier in dual mono or bridged mono mode, you must install the equalizer card in Channel 2. Page 21 5. Reconnect the ribbon cable. Page 22 5. Connect all input connections to the amplifier, and line cord to the wall. Figure Page Input Wiring 5. Use shielded coaxial cable to conduct the signal from the source mixer, equalizer, CD player to the amplifier. Page Unbalanced Operation 5. For the quick connect terminal block, use the female connector provided.
Pin 2 carries the — low, inverting side of the signal. Pin 1 is ground see Figure When using the standard input module for either amplifier, you can reverse the polarity of the balanced inputs by changing four jumpers located on the input board, just behind the input connectors. Page 25 5. To reference the input differential amplifier for the correct gain, short pin 3 to pin 1 see Figure Figure 29 Use Class 2 Wiring For bridged operation.
Page 26 5.
0コメント